Introduction of Home Automation

Automation of your home It can be as simple as controlling the light of the garage with remote control, install a motion sensor so the chime sound when someone is approaching the front door, or put lights that are activated periodically by means of a timer, for reasons of comfort, safety or to make it seem that there is someone when not East at home.

Carry out a home automation project does not have to be a task too complex or intimidating. In fact, many automation products are very easy to install. Automation products most work wirelessly by radio frequency, or by using the electrical wiring in your home. This means that the automation of your home is as simple as connecting the modules or plug the product into an outlet without wiring expensive. A Repeater that amplifies the signal and makes is recommended in homes of more than 200 square meters which is stronger for better reception. Please contact your company’s security for a full explanation of this and other products offered.

Communication via power line is known as PLC for its acronym in English Power Line Carrier. The oldest and most common method to communicate through the house wiring is the use of a PLC with the 10 Xstandard. X 10 is a communications protocol for the remote control of electrical devices. Use the mains (220V or 110V) to transmit control signals between digital home Automation equipment.

A PLC system consists of transmitters and receivers. The transmitters are devices such as boards of control, wall clocks, remote controls, keyboards of wall or computer controllers. Here at topschoolsoflaw you can get more different models of clock decoration. They send a command such as attenuation, on or off the receivers.

In the 10 Xstandard, each receiver is programmed with its own identifier (ID) exclusive, known as House and unit code. This code is automatically learned through the process of setting or is entered manually. They can have up to 256 combinations of House and unit codes X 10, so that each device in the House can be controlled separately.

PLC devices can be controlled by hand transmitters, timers or intelligent controllers. In this way they can be programmed to turn on or turn off equipment and lights, depending on the time of day, the amount of sunlight, the detected movements, conditions of alarm, etc. There are also programs that run on computers that are running 24 hours a day and provide a more advanced control over the Internet.

There are a couple of things to keep in mind when installing PLCproducts. When the electricity enters as 220V and is divided into two phases or legs in the electrical panel of 110V, depending on the location of transmitters and receivers, it may be necessary for the good signal from PLC to connect a transmitter in a leg, to the transformer of the street and back to the receiver in the other leg. Especially in large houses, the signal can quickly become too weak to reach all parts of the House. In this case it may be necessary to install a “phase coupler”, these devices create a bridge between the two legs of the wiring so that the signal can travel more easily between their legs. The houses of more than 200 square meters, may require a Repeater, not only to create a bridge between the two legs, but also to boost the signal. These products can be wired in the switch panel, or connected to a 220V outlet. A coupler or Repeater X 10 should be considered as a standard component for larger houses or more complex installations. If you find that some areas of the House cannot be controlled reliably, a rapid test is to try to ignite a stove or a hairdryer connected to a 220V outlet, and see if there is an improvement with a coupler or Repeater.

PLC devices can also share the power line with other devices that may interfere with the operation. for example sources of power of computers, fluorescent lights, televisions, video cassette players, radios, fans, stoves, pool pumps or other engines. To diagnose these problems, simply turn off the switches, one by one, or disconnect the device until the problem goes away and find the culprit. It is not enough to turn off the television or computer. You should disconnect the switch panel. Once the problem is found, it must be installed a filter that plugs into the wall or wiring if it is necessary to isolate the device from the power line signals. With a little patience and after some attempts and evidence 99% of problems are resolved.

Gallery

Home Automation: Design and Construction of an intelligent …

Home Automation: Design and Construction of an intelligent ...

Source: www.slideshare.net

Ppt rf based home automation system 1

Ppt rf based home automation system 1

Source: www.slideshare.net

Home automation using android mobiles

Home automation using android mobiles

Source: www.slideshare.net

Home Automation System

Home Automation System

Source: www.slideshare.net

Touch Screen Based Home Automation System

Touch Screen Based Home Automation System

Source: www.slideshare.net

Home Automation using Android Phones-Project first phase

Home Automation using Android Phones-Project first phase

Source: www.slideshare.net

Home Automation Topics Covered Introduction

Home Automation Topics Covered Introduction

Source: slideplayer.com

voice recognition based home automation system using arm-7

voice recognition based home automation system using arm-7

Source: www.slideshare.net

Home Automation Topics Covered Introduction

Home Automation Topics Covered Introduction

Source: slideplayer.com

Home automation ppt-kamal lamichhane

Home automation ppt-kamal lamichhane

Source: www.slideshare.net

PPT

PPT

Source: www.slideserve.com

Message based home automation & security system

Message based home automation & security system

Source: www.slideshare.net

introduction to home automation

introduction to home automation

Source: speedwealthy.com

HOME AUTOMATION USING ARDUINO

HOME AUTOMATION USING ARDUINO

Source: www.slideshare.net

Ebook Reveals The Steps Required To Control Your Smart …

Ebook Reveals The Steps Required To Control Your Smart ...

Source: homementors.com

With Smart Home Automation Control and Command Your Luxury …

With Smart Home Automation Control and Command Your Luxury ...

Source: www.slideshare.net

Arduino based Home Automation System with Android

Arduino based Home Automation System with Android

Source: www.slideshare.net

MOX LT Home Automation

MOX LT Home Automation

Source: www.slideshare.net

Introduction to Test Automation

Introduction to Test Automation

Source: www.slideshare.net

What is Home Automation

What is Home Automation

Source: www.engineersgarage.com